KitchenAid covers the widest span of any brand we service, from built-in wall ovens and 48-inch ranges to French-door refrigerators and dishwashers, and nearly all of it runs on the Whirlpool-family F#-E# fault-code system. That shared platform is an advantage: the F number names the failure category and the E number the specific fault, so a technician reading both digits knows which subsystem to test first. We still confirm the failed part on the appliance, because a keypad fault and a control-board fault can look alike until they are metered. We service KitchenAid cooking, refrigeration, and dishwashers across the Denver metro.
Models We Service
- Ranges: KitchenAid Smart Commercial-Style and slide-in gas, dual-fuel, and electric ranges
- Wall ovens: Single, double, and combination wall ovens with convection and steam
- Cooktops: Induction, gas, and electric cooktops
- Refrigeration: Built-in, French-door, and side-by-side refrigerators
- Dishwashers: KitchenAid built-in dishwashers with third rack and ProWash
Error & Fault Codes
KitchenAid uses the Whirlpool F#-E# system. The most common codes and what they usually mean:
| Code | Meaning | Typical Fix |
|---|---|---|
F2-E0 | Stuck key or shorted keypad, possible over-temp | Test keypad and control, replace faulty part |
F9-E0 | Door-lock / latch circuit fault | Test lock motor and switches, repair circuit |
F1-E# | Control board internal fault | Test and replace control board |
F3-E# | Oven temperature sensor open or shorted | Test and replace sensor, check harness |
| Dishwasher no drain | Clogged filter, hose, or drain pump | Clear drain path, test pump |
Kitchenaid Showing an F-Code?
Book a diagnosis. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.
Common Problems We Fix
The KitchenAid calls we run most span the whole kitchen: ovens that lock up with an F2-E0 keypad fault, ranges that throw F9-E0 during self-clean, refrigerators that drift warm, and dishwashers that will not drain. On the cooking side, sensor codes leave the oven baking off-temperature and a lost gas burner points to an igniter. On refrigeration, warm cabinet temperature comes back to a fan, an iced evaporator, or a control board, and a dead ice maker usually needs the module or fill valve. On dishwashers, a no-drain is a clogged filter, hose, or pump, and wet dishes point to the heating element or vent. We confirm the failed part on the appliance and verify a clean cycle before we close the job.