Dacor built its name on American-made cooking appliances and has since moved under the Samsung umbrella, which brought newer touch-controlled ranges and column refrigeration alongside the classic Renaissance and Epicure lines still in many Greenwood Village kitchens. Across both eras, the ovens display F-style fault codes when the control senses a problem, and most trace back to the temperature sensor or a relay. A code is a starting point, not the whole story, so we confirm each fault on the appliance with meters before we replace a part. We service Dacor ranges, wall ovens, cooktops, and refrigeration across the Denver metro.
Models We Service
- Ranges: Modernist, Contemporary, Professional, Renaissance, and Epicure gas and dual-fuel ranges
- Wall ovens: Modernist and Renaissance single and double electric wall ovens with convection
- Cooktops: Dacor gas, induction, and electric cooktops and rangetops
- Refrigeration: Dacor built-in and column refrigerators and freezers
Error & Fault Codes
Dacor ovens use F-style fault codes. The exact numbering varies by generation, but they group into a small set of subsystems. The table below shows how we approach the codes we see most, always confirming the cause before replacing a part.
| Code Group | Meaning | Typical Fix |
|---|---|---|
F1 / sensor | Oven temperature sensor open or shorted | Test and replace sensor, check harness |
F2 / over-temp | Runaway temperature or stuck relay | Test relay board, replace if welded |
F3 / key or control | Control panel or keypad fault | Test control, replace panel or board |
| Oven no heat | Bake/broil element or igniter fault | Test element circuit, replace part |
| Refrigerator warm | Fan, evaporator frost, or control fault | Restore airflow, replace fan or board |
Dacor Showing an F-Code?
Book a diagnosis. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.
Common Problems We Fix
The Dacor calls we run most are ovens that post an F-code and stop, ranges that bake unevenly, and refrigeration that drifts warm. On the ovens, a sensor or relay fault is the usual trigger, and a cold cavity comes back to an element or, on gas models, a weak bake igniter. On the cooktops, a lost gas burner is often an igniter or spark module, and an induction zone dropping out points to a coil or control. On refrigeration, warm cabinet temperature traces to a condenser or evaporator fan, an iced coil, or a control board. We confirm the failed part on the appliance, fit a OEM replacement, and verify the appliance runs to spec before we close the job.